How Should Motorcycle Gloves Fit?
The short answer
Motorcycle gloves fit when your fingertips just touch the ends with your fingers curled around a grip, the knuckle armor sits squarely over your knuckles in the riding position, the palm has no loose folds, and the wrist closure is snug enough that the glove can't be pulled off in a slide.
Motorcycle gloves are protective gear, so they have to stay on your hands in a crash and keep armor where it belongs. They also have to let you work the clutch and brake levers precisely. Judge them with your hands in the riding position, fingers curled as if holding the grips, not with your hands flat.
Motorcycle Gloves fit map
- 1Fingertips in the riding position
- 2Knuckle armor
- 3Palm
- 4Fingers
- 5Thumb
- 6Wrist closure
Motorcycle Gloves fit checklist: 6 points
| Checkpoint | Fits right | Too tight or short | Too loose or long |
|---|---|---|---|
| Fingertips in the riding position | With your fingers curled around an imaginary grip, your fingertips just touch the ends of the glove without pressing. | Too short: your fingertips jam into the ends when you curl your fingers, which leads to numbness on longer rides. | Too long: there's spare material at the tips that catches on levers and switches. |
| Knuckle armor | When you grip, the hard knuckle protector sits centered over your knuckles and doesn't press into them. | The armor presses hard into the knuckles or the back of the hand when you make a fist. | The armor slides off to the side or sits behind your knuckles on the back of the hand. |
| Palm | The palm and any slider pad lie smooth against your hand, with no folds when you grip the bar. | The palm stretches tight and pulls the fingers back, making it tiring to hold the grip. | Loose material bunches in your palm when you grip, which hurts feel and causes hot spots. |
| Fingers | You can reach and pull the clutch and brake levers with two or four fingers without the glove resisting. | The fingers feel stiff or the seams bite between your fingers when you pull a lever. | Fingers twist inside the glove, so you can't feel the levers precisely. |
| Thumb | The thumb reaches the end of its stall and you can easily reach the turn signal and horn buttons. | The thumb is pulled toward the palm or the seam at its base digs in. | The thumb tip is empty, making switchgear clumsy. |
| Wrist closure | With the wrist strap fastened, you can't pull the glove off by tugging on its fingertips. | The strap restricts your wrist movement or blood flow. | The glove can be tugged off with the wrist strap fastened, so it could come off in a slide. |
Gauntlet, short-cuff and seasonal gloves
Glove style decides how the cuff works with your jacket. The finger and palm fit stays the same.
- Gauntlet (long-cuff) gloves
- Cover the wrist and lower forearm and are worn over the jacket sleeve, which keeps wind and rain from blowing up the arm. Check that the gauntlet closes over your sleeve without being forced.
- Short-cuff gloves
- End at the wrist and are worn under the jacket sleeve. The jacket cuff should cover the glove cuff without a gap of bare skin when you reach for the bars.
- Racing gloves
- Usually have pre-curved fingers, extra armor and a double wrist closure. They're cut for the riding position, so they may feel awkward with your hand flat.
- Winter and waterproof gloves
- Insulation and membranes add bulk. Allow a little more room at the fingertips, but check that you can still operate the levers precisely.
- Summer and mesh gloves
- Thin and well ventilated. Fit should be close, because thin leather and mesh stretch with use.
How to measure for motorcycle gloves
Most brands size by palm circumference and sometimes hand length.
- Use a soft tape measure on your throttle hand (usually the right), which is often slightly larger.
- Measure around your palm just below the knuckles, leaving out the thumb.
- Measure your hand length from the tip of your middle finger to the crease at the base of the palm.
- Check both measurements against the brand's size chart.
- If circumference and length point to different sizes, choose by length for fingertip fit and by circumference for palm fit, then try both on.
Try gloves on while sitting on your bike, or with your hands curled as if gripping, and work the levers if the shop allows.
Common problems and fixes
- Numb fingertips on long ridesThe gloves are too short when your fingers curl. Size up or try a pre-curved design.
- Knuckle armor presses into your handThe armor isn't lined up with your knuckles. Try a size where it sits centered when you grip, or a model with softer, segmented armor.
- The gauntlet won't close over your jacket sleeveLook for gloves with wider gauntlets or wear a short-cuff glove under the sleeve instead.
- Gloves are hard to get on with sweaty handsThin glove liners help, and gloves with a wrist-to-cuff vent make it easier. Don't size up just for this.
Break-in and stretch
Leather motorcycle gloves usually ease slightly as they break in, especially across the palm. Textile gloves stretch less. New leather gloves should start snug but not painful, and you should still be able to operate the levers from the first ride.
When to replace motorcycle gloves
Replace gloves after a crash in which they slid on pavement, or when the palm is worn thin, seams are opening, or the wrist strap no longer holds. Armor that's cracked or loose should also be replaced.
What to shop for
These are search links to a retailer. If you buy through them we may earn a commission, at no cost to you. How we make money.
- Leather gauntlet motorcycle glovesSee options on AmazonMaximum coverage and a seal over the jacket sleeve for touring and sport riding.
- Short-cuff motorcycle gloves with knuckle armorSee options on AmazonEasier on and off for commuting, with protection over the knuckles.
- Waterproof winter motorcycle glovesSee options on AmazonInsulated and sealed for cold-weather riding; allow a little extra fingertip room.
- Mesh summer motorcycle glovesSee options on AmazonVentilated for hot weather while keeping palm and knuckle protection.
Questions people ask
Should motorcycle gloves be tight?
Snug, not tight. They should stay on with the wrist strap closed and the armor should sit over your knuckles, but you should be able to grip and pull levers comfortably.
How much room should be at the fingertips of motorcycle gloves?
With your fingers curled as if gripping, your fingertips should just touch the ends. If they press, the gloves are too short.
Do motorcycle gloves stretch?
Leather gloves stretch a little, mostly in the palm. Textile and mesh gloves stretch less. Buy them snug, but not painful.
Should motorcycle gloves go over or under the jacket?
Gauntlet gloves go over the jacket sleeve; short-cuff gloves go under it. Either way, there should be no exposed skin when you reach for the bars.
How do I know if motorcycle gloves are too big?
If you can pull them off with the wrist strap closed, if the armor slides off your knuckles, or if the palm bunches when you grip, they're too big.
Updated November 19, 2026. How we write our guides.