Will a Micro ATX Motherboard Fit in an ATX Case?
The short answer
Yes. A micro ATX motherboard measures 9.6 × 9.6 in (24.4 × 24.4 cm), the largest size the microATX spec allows; the ATX case is 12 × 9.6 in (30.5 × 24.4 cm), the motherboard area it is built for (a full-size ATX board). The ATX specification lines ATX mounting holes up with the microATX ones, and notes that this lets many ATX cases accept microATX boards. You use a subset of the same standoffs and get fewer expansion slots; the I/O shield and power connectors work the same.
Dimensions compared
| Measurement | micro ATX motherboard | ATX case | Difference |
|---|---|---|---|
| Width | 9.6 in (24 cm) | 12 in (30 cm) | −2.4 in (6 cm) |
| Length | 9.6 in (24 cm) | 9.6 in (24 cm) | same |
ATX case: the motherboard area it is built for (a full-size ATX board).
What happens if you try, and what to do instead
- Remove stray standoffs
- Take out any standoff that doesn't line up with a hole in the smaller board; a stray one can short the back of the board.
- Check cable reach
- The board's lower edge ends higher in the case, so front-panel and power cables may need to reach a little further.
- Confirm the case's form factor list
- Check that microATX appears in the case's supported motherboards; most ATX cases list it.
What to shop for
These are search links to a retailer. If you buy through them we may earn a commission, at no cost to you. How we make money.
- Motherboard standoff kitSee options on AmazonSpare standoffs for any hole layout
- Micro ATX motherboardSee options on AmazonFits ATX and micro ATX cases
Questions people ask
Does micro ATX fit in an ATX case?
Yes. A micro ATX board is at most 9.6 × 9.6 in and its mounting holes line up with ATX's, inside a case built for a 12 × 9.6 in board.
Can an ATX motherboard fit in a micro ATX case?
Usually not. A full ATX board is longer than a micro ATX case is built for, unless the case lists ATX support.
Will a mini ITX board fit in an ATX case?
Yes. Mini ITX also uses holes that line up with ATX positions, and ATX cases usually list it as supported.
Do I need different standoffs for micro ATX?
No. The same standoffs work; you just use fewer of them, in the positions that match the board.
Is a micro ATX build in an ATX case a bad idea?
No. It leaves more room for airflow and cables; the trade-off is fewer expansion slots.
Where the numbers come from
Devices, cases and PC parts
| Question | Answer |
|---|---|
| Will a Nintendo Switch 2 Fit in a Switch 1 Case? | No |
All size compatibility questions or check any combination with the mattress, sheet and frame checker.